Anyone using Cali raised stiffeners on Tacoma and a drawer system?

I recently ordered the cali raised stiffeners for my Tacoma to support the gfc and noticed the bottom bracket that attaches to the bed is not flat. Wondered if anyone has these and using a drawer system? I’m concerned I might not be able to pull a drawer out because it would be blocked by the bottom bracket.

I have total chaos bed stiffeners. They seem a little smaller profile than cali raised however they still have a small ‘lip’ to them. I believe if you have a 3/4” base for a drawer setup, you may have enough clearance. Or you might have to build narrower drawers.