I have the non-pro v2 camper. I’m wondering how folks have wired the upstairs lighting. I was planning on running the wiring down the room extrusion to the front wedge and drilling a hole to run the wire to the battery but I see on the pro version the wiring comes vertically down.
Has anyone wired it this way? Any rubber grommets that fit the thickness of the panels?
I currently just have a small battery pack that powers my lighting up stair because i didnt want to drill yet but going to do something similar to this this summer.
i just use a pair of 16awg wires and then run them through the transforma-floor in the back.
sure, it pinches a tiny bit but it’s been over a year and i have no issues.
16awg wires are thin enough to go through the gap in the corner with minimal damage